11.7 Dierences between oine and online parameterization
Overview
All oine settings and therefore all data relating to parameterization, device conguration and
quick startup must be loaded to the converter in order to take eect.
To parameterize commissioning parameters in online mode, the editing mode must be
activated. Restore points are created during parameterization. If the online connection to
the converter is lost and a new connection is established, editing can continue from the most
recently backed-up parameterization status.
SafetyIntegratedFunctions
In the oine and online modes, SafetyIntegrated Functions can only be congured if the edit
mode is activated.
After completion of oine editing, the conguration can be loaded into the converter and
executed without any further postprocessing.
Requirement
• The drive has been completely created and specied in the device conguration.
• For the online parameterization:
There is an active online connection between the converter and the operating unit.
• Activate editing:
Only possible if access is exclusively via the currently connected operating unit.
Editing cannot be activated if the converter is being simultaneously accessed by multiple
operating units via Startdrive or the web server. The converter indicates that other accesses
are active and refuses to activate editing.
• Access if project protection is activated:
If project protection is activated, authentication is required.
The rights required for editing are assigned to your user account and activated.
Activate/nish editing
Display Description
Editing mode is not activated.
Start editing with .
Editing mode is activated.
Finish editing with .
Note
When editing nishes, a new restore point is created automatically. The current conguration is stored in a
power-independent manner.
Commissioning (Startdrive)
11.7Dierences between oine and online parameterization
SINAMICS G220 converter
292 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB
To Next Page
Loading...
