Siemens SINAMICS G220 - Quick Setup

Commissioning involves the following steps:
• Basic settings:
If the converter has already been commissioned, then the web server jumps to the basic
settings.
The following settings are required for a brand-new converter:
– Language, date, time
• Security settings:
The settings are con󹪝gured with the help of the Security Wizard.
You can 󹪝nd more information in section "Security Wizard (Page214)".
• Quick setup:
Menu "Commissioning" > "Quick setup"
– Entry or checking of motor and encoder data
– Limit values and I/O con󹪝guration.
• Advanced setup:
Menu "Commissioning" > "Advanced setup"
Advanced setup includes all the quick setup settings plus additional options and drive
functions.
• Optimize motor:
Menu "Commissioning" > "Optimization"
The Optimization function measures the mechanical drive train using short test signals and
adapts the controller parameters to the mechanics installed.
• Safety Integrated commissioning:
Menu "Commissioning" > "Safety Integrated"
Setting of the Safety Integrated Functions
• Test motor operation:
Action bar > "Control panel"
Test of motor operation using the control panel in jog mode or continuous operation
• Backup:
Menu "Backup and restore"
We recommend backing up the drive settings after commissioning.
More information
Information about user management and the settings can be found on the Internet:
Industrial Cybersecurity Con󹪝guration Manual (https://
support.industry.siemens.com/cs/ww/en/view/109810578)
10.5.1.2 Quick setup
Overview
Quick setup comprises the basic settings that are required to commission the converter.
Commissioning (web server)
10.5Functions and menus
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 225