Siemens SINAMICS G220 - Testing the Converter Configuration; Safety Integrated Commissioning

10.5.1.5 Testing the converter con󹪝guration
Overview
After commissioning, the web server allows you to test the converter con󹪝guration set up in jog
mode or continuous motion via the control panel.
Description
To test the con󹪝guration, the control panel must be open and the speed setpoint entered.
There are 2 ways of opening the control panel:
• Button "Finish quick setup" > Dialog query with selection option "Open control panel"
• Action bar > "Control panel"
Figure10-7 Testing the converter con󹪝guration via the control panel
More information
You can 󹪝nd more information in Chapter "Control panel (Page273)".
10.5.1.6 Safety Integrated commissioning
Overview
Commissioning the Safety Integrated Functions of the converter includes the following:
• Selecting the functions
• Parameterizing the functions as required for the application
• Control of the functions
Commissioning (web server)
10.5Functions and menus
SINAMICS G220 converter
232 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB