Siemens SINAMICS G220 - Inputs and Outputs

17.10 Inputs and outputs
Technical data
Table 17-20 Technical data of inputs and outputs
Property Data
24 V supply There are 2 options for the 24 V supply:
• Internal power supply
The converter generates its 24 V power supply internally from the line voltage.
• Contact-safe SELV power supply via terminal strip X124 with 20.4V-28.8V DC
Maximum current consumed: 3A
The supply voltage must not exceed 60V in the event of a fault.
Voltages in excess of 60V will permanently damage the converter.
Output voltages
• 24V
Maximum output current 200mA
• 10V ± 0.5V
Maximum output current 10mA
Digital input Type 3 according to IEC61131-2
Isolated using an optocoupler
Maximum permissible input voltage 30V
Input voltage for "low" state: <5V
Input voltage for state "high">11V
Current for state "high" 2.5... 4.0mA
Response time 0.25ms
Rapid input

DI5
Pulse frequency when used as pulse train input 32kHz
Response time when used as measuring probe input 0.01ms
Analog input Di󹪜erential input
16-bit resolution
Response time 4ms
Overvoltage protection up to ±35V
Operating mode selection:
• 0V...10V or -10V...10V: Input resistance 100kΩ, maximum voltage35V
• 0mA...20mA, 4mA...20mA: Input resistance 120Ω, maximum voltage8V, maximum
current65mA
Digital output/relay output Transistor output DO0: Reverse polarity protection
Relay outputs DO1 and DO2
Response time 3ms
30V DC / ≤0.5A for a resistive load
Technical data
17.10Inputs and outputs
SINAMICS G220 converter
818 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB