Siemens SINAMICS G220 - Basic Settings; Security Wizard

Description of function
If the web server is called, a forwarding function starts automatically to de󹪝ne the basic settings.
When doing, this several function views are run through.
The function views contain the following settings:
• Basic settings (Page214)
• Security settings (Page214)
10.4.3 Basic settings
Overview
Initial basic settings are de󹪝ned in the function view.
Requirement
The web server is being called for the 󹪝rst time.
Description of function
The basic settings are as follows:
• Preferred language of the user interface
• Converter date and time; either manually or via NTP
After these entries have been made, using the "Next" button, you can continue to the
Security Wizard.
10.4.4 Security Wizard
Overview
The Security Wizard o󹪜ers the following settings:
• UserManagement&AccessControl (UMAC)
• Access to the integrated web server via the 󹪝eldbus or service interface
• Drive data encryption
Commissioning (web server)
10.4Getting Started
SINAMICS G220 converter
214 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB