Siemens SINAMICS G220 - Motors that Can be Operated

3.8 Motors that can be operated
Requirement
Induction motors are permissible with a motor power in the range of 25% to 125% of the
converter power.
NOTICE
Insulation failure due to unsuitable third-party motor
A higher load occurs on the motor insulation in converter mode than with line operation.
Damage to the motor winding may occur as a result.
• Observe the notes in the System Manual "Requirements placed on third-party motors".
Description
The converter supports the operation of the following motors:
• Synchronous motors from Siemens
• Induction motors from Siemens, e.g. SIMOTICS 1PH8, SIMOTICS 2KJ3
• Siemens induction motors, e.g. SIMOTICS 1LE1, SIMOTICS 1LE5, SIMOTICS 1LE6, SIMOTICS
1PC1
• Reluctance motors from Siemens, e.g. SIMOTICS 1FP1, SIMOTICS 1FP3, SIMOTICS 1PH8
• Motors from other manufacturers:
– Synchronous motors
– Induction motors
– Reluctance motors
More information
You can 󹪝nd more information on the Internet:
Requirements placed on third-party motors (https://support.industry.siemens.com/cs/ww/en/
view/109792187)
The System Manual is also valid for SINAMICS G220.
Description
3.8Motors that can be operated
SINAMICS G220 converter
58 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB