Siemens SINAMICS G220 - Retrieving Component Information with a Code Scanner App

Procedure
Figure13-12 IP address of the converter
Proceed as follows to connect to the converter web server via the QR code of the IP address:
1. In the navigation bar, navigate to the "Support" menu.
Con󹪝rm the selection using the "OK" key.
2. Select the "Scan IP address" menu item.
Con󹪝rm the selection using the "OK" key.
3. Press the "OK" key to access the QR code from the information window.
4. Select the interface via which the converter is connected.
Con󹪝rm the selection using the "OK" key.
The IP address of the converter and the corresponding QR code are displayed.
5. Scan the QR code of the IP address using your mobile device.
A link is displayed on your mobile device.
6. Open the link.
– The connection to the web server is established.
– The converter web server is displayed.
13.5.5.2 Retrieving component information with a code scanner app
Overview
A component-speci󹪝c QR code is provided in menu "Support" > "Component".
Scanning the QR code with your mobile device takes you to the converter product page on
the Siemens Industry Online Support portal.
Requirement
You have installed an app for scanning QR codes on your mobile device.
Operation and monitoring with SINAMICS SDI Standard
13.5Functions
SINAMICS G220 converter
318 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB