Siemens SINAMICS G220 - Motor Holding Brake

• p0215=2 Siemens braking resistor
All of the settings required to thermally monitor the braking resistor are saved in the
converter.
• p0215=3 Third-party braking resistor
Additional settings are required to thermally monitor the braking resistor.
Parameter p0219[0] de󹪝nes the maximum braking power that the braking resistor is
expected to absorb.
3
W
S>@
Figure14-192 Example of maximum braking power in an application
Example
The following are typical applications for dynamic braking:
• Centrifuges
• Horizontal conveyors
• Vertical and inclined conveyors
• Hoisting gear
You can 󹪝nd an example for con󹪝guring and commissioning a drive with braking resistor
on the Internet: Dimensioning and commissioning of serial hoisting equipment (
https://
support.industry.siemens.com/cs/ww/en/view/103156155).
Parameters
The following list contains the parameters of the "Dynamic braking" function.
14.11.11 Motor holding brake
Overview
A motor holding brake holds a switched-o󹪜 motor in place.
When controlled as follows, the "Motor holding brake" function minimizes the wear of an
electromechanical brake:
• The brake opens once the motor is magnetized.
• The converter switches o󹪜 the motor when the motor holding brake is closed.
Functions
14.11Drive functions
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 605