Siemens SINAMICS G220 - Functions; Adapt Start Page; Diagnostics Menu; Displaying Faults and Alarms

13.5 Functions
13.5.1 Adapt start page
Overview
You can adapt the start page to your requirements as follows:
• Display of the view
• Display of the parameters
• Units and decimal places for the output 󹪝elds
Procedure
Figure13-4 Start screen
Proceed as follows to adapt the start page:
1. In the navigation bar, navigate to the "Start screen" menu.
Con󹪝rm the selection using the "OK" key.
The "Edit view" dialog opens.
2. Adapt the start page to your requirements.
13.5.2 "Diagnostics" menu
13.5.2.1 Displaying faults and alarms
Overview
Faults and alarms are listed in menu "Diagnostics" > "Messages":
• "Messages" list
The list contains active and/or historical faults and alarms
• Description of speci󹪝c faults and alarms
Operation and monitoring with SINAMICS SDI Standard
13.5Functions
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 309