Siemens SINAMICS G220 - About this Manual; Content; Target Group

1.2 About this manual
1.2.1 Content
Overview
These Operating Instructions provide a summary of all of the information required to operate
the converter under safe conditions.
The Operating Instructions enable the target groups being addressed to assembly, install,
connect, and commission the converter safely and in the correct manner.
To illustrate possible application areas for our products, typical use cases are listed in this product
documentation and in the online help. These are purely exemplary and do not constitute a
statement on the suitability of the respective product for applications in speci󹪝c individual cases.
Unless explicitly contractually agreed, Siemens assumes no liability for such suitability.
Suitability for a particular application in speci󹪝c individual cases must be assessed by the user,
taking into account all technical, legal, and other requirements on a case-by-case basis. Always
observe the descriptions of the technical properties and the relevant constraints of the
respective product contained in the product documentation.
1.2.2 Target group
Overview
The Operating Instructions address the following target groups:
• Planning engineers
• Project engineers
• Technologists
• Installation personnel
• Programmers
• Commissioning engineers
• Machine operators
• Service and maintenance personnel
Introduction
1.2About this manual
SINAMICS G220 converter
18 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB