Siemens SINAMICS G220 - Changing the Converter Date and Time

To display con󹪝guration information for the interfaces, proceed as follows:
1. In the navigation bar, navigate to the "System" menu.
Con󹪝rm the selection using the "OK" key.
2. Select the "Settings" menu item.
Con󹪝rm the selection using the "OK" key.
3. Select the "Interfaces" menu item.
Con󹪝rm the selection using the "OK" key.
4. Select the menu item for the required interface.
Con󹪝rm the selection using the "OK" key.
– The con󹪝guration information is displayed.
– "Web server access via HTTP or HTTPS": The selection is activated/deactivated by pressing
the "OK" key.
13.5.4.3 Changing the converter date and time
Overview
You change the converter date and time in menu "System" > "Settings" > "Date and time".
Various options are available for setting the date format and for adopting the date, the time
and the time zone of the converter:
• Set manually
• Time zone
• Date
• Time
• Date format
Procedure
Figure13-10 Changing the date and time
Proceed as follows to change the date and time:
1. In the navigation bar, navigate to the "System" menu.
Con󹪝rm the selection using the "OK" key.
2. Select the "Settings" menu item.
Con󹪝rm the selection using the "OK" key.
Operation and monitoring with SINAMICS SDI Standard
13.5Functions
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 315