Siemens SINAMICS G220 - Guided Quick Startup

11.5 Guided quick startup
Requirement
• The drive has been completely created and speci󹪝ed in the device con󹪝guration.
If the drive does not have a complete speci󹪝cation, the guided quick startup cannot be used.
A corresponding message appears.
• Access if project protection is activated:
If project protection is activated, authentication is required.
The rights required in order to use the guided quick startup are assigned to your user account
and activated.
• Use of a controller:
If a controller is used, it must be connected to the drive in the topology view and network
view. The connection between the devices must be con󹪝gured.
• Optional: The operating unit is physically connected to the drive via a LAN cable.
Description of function
You can de󹪝ne the following basic settings in the setting areas with the same name:
• "Conn. to PLC":
This setting area determines whether the drive is used with a controller. This also de󹪝nes the
control authority.
• "Operating mode":
This setting area determines the required control mode of the drive.
• "Limits":
This setting area determines the minimum and maximum values of the motor used, for
example current, speed, run times.
• "I/O con󹪝guration":
Setting area for con󹪝guration of the analog or digital inputs and outputs.
• "Telegrams":
Telegrams are suggested depending on the selected defaults. Telegrams and detailed
settings can be speci󹪝ed independently of the suggested telegrams. Settings are only
possible o󹪠ine.
• "Rotate&optimize":
This setting area determines the basic settings for the motor data identi󹪝cation.
The basic setting take e󹪜ect the 󹪝rst time the motor is switched on. Optional: Test the settings
in operation.
• "Summary":
This display area is an overview of all con󹪝gured settings.
Optional: If no changes are necessary, transfer the settings directly to the device.
More information
Detailed information about the guided quick startup can be found in the information system of
the TIAPortal.
Commissioning (Startdrive)
11.5Guided quick startup
SINAMICS G220 converter
290 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB