Siemens SINAMICS G220 - Page 291

Settings changed in the quick startup might also apply to other setting areas in the quick
startup.
Table 11-1 Status indicators after changes
Icon Meaning
The defaults in this setting area are valid.
The settings in this setting area are valid.
The settings were con󹪝gured in this setting area or in another setting area.
The program changed the settings in this setting area.
Possible causes are:
• Settings that are not automatically valid were con󹪝gured in other setting areas.
• The device con󹪝guration was changed.
The settings in this setting area must be checked and adjusted.
Settings in the quick startup areas might also apply to previously con󹪝gured settings. Check
and adjust the relevant settings.
Table 11-2 Status indicators for deviating settings
Icon
1)
Meaning
Shows deviating settings.
Inputs possible.
Input required.
1)
A note appears when you mouse over.
Commissioning (Startdrive)
11.4Overview of the guided quick startup
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 289