Siemens SINAMICS G220 - Operation and Monitoring Menu; Manually Starting and Stopping the Motor

Procedure
Proposed function: Acknowledge messages
Alternative function: Switch display of historic messages on and o󹪜
Figure13-5 Diagnostics menu
To display faults and alarms, proceed as follows:
1. In the navigation bar, navigate to the "Diagnostics" menu.
Con󹪝rm the selection using the "OK" key.
The "Diagnostics" menu opens.
2. Select the "Messages" menu item.
Con󹪝rm the selection using the "OK" key.
The "Messages" list is displayed.
3. To display the description of a speci󹪝c fault or alarm, select the message concerned.
Press the "OK" key.
13.5.3 "Operation and monitoring" menu
13.5.3.1 Manually starting and stopping the motor
Overview
You manually start and stop the motor using 2 keys.
Requirement
• The conditions for starting the motor are met.
• The converter is in manual mode.
Procedure
To start or stop the motor manually, press the following keys:
• Start motor: ON key
• Stop motor: OFF key
Operation and monitoring with SINAMICS SDI Standard
13.5Functions
SINAMICS G220 converter
310 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB