Siemens SINAMICS G220 - Configuring the OM-Iiot Option Module

Interfaces
Under "Interfaces", the web server provides information about the status and the settings of
the interfaces of the converter:
• The IP address of the X-127 service interface is con󹪝gurable.
• The interface settings for the X150 󹪝eldbus interface are displayed. Changes can only be
made in advanced setup.
Drive date and time
Under "Drive date and time", the web server provides options for setting the date format and
for obtaining the date, time and time zone of the converter.
Maintenance
The web server calculates the wear limit of the converter fan.
After the fan is replaced, the wear calculation is reset manually. The calculation then starts
from the beginning.
Support settings
Under "Support settings", the web server provides the option to store additional support and
hotline data. The web server displays these data in the function view "Support".
10.5.6.2 Con󹪝guring the OM-IIoT option module
Overview
When con󹪝guring option module OM-IIoT, you de󹪝ne the communication between the OM-IIoT
and the edge device.
Requirement
"Display all parameters" is selected under "System > Settings".
The procedure includes as example the "Drive System Framework" app that runs in the edge
device.
Commissioning (web server)
10.5Functions and menus
SINAMICS G220 converter
264 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB