Siemens SINAMICS G220 - Directives and Standards

3.7 Directives and standards
EC Declaration of Conformity
European Machinery Directive
The converters ful󹪝ll the requirements stipulated in the Machinery Directive 2006/42/EC, if
they are covered by the application area of this directive.
However, the use of the converters in a typical machine application has been fully assessed
for compliance with the main regulations in this directive concerning health and safety.
European Low-Voltage Directive
The converter ful󹪝lls the requirements stipulated in the Low-Voltage Directive 2014/35/EU,
insofar as they are covered by the application area of this directive.
Directive 2011/65/EU
The converters ful󹪝ll the requirements stipulated in Directive 2011/65/EU relating to the
restriction of the use of certain hazardous substances in electrical and electronic devices
(RoHS).
European EMC Directive
The compliance of the converter with the regulations of the Directive 2014/30/EU has been
demonstrated by full compliance with the IEC/EN 61800-3.
UKCADeclaration of Conformity
The converter complies with the requirements for the British market (England, Wales and
Scotland).
Underwriters Laboratories (North American market)
Converters provided with the test symbols displayed ful󹪝l the requirements stipulated for the
North American market as a component of drive applications.
Description
3.7Directives and standards
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 55