Performing commissioning
① Individual function views are called up by clicking on the corresponding entry.
② Individual function views are called up by clicking on the corresponding eld.
③ The button is activated when the data in the "Hardware data" setting area is congured and all entered values are valid.
Figure10-6 Calling advanced setup function views
Further conguration options are displayed by clicking on the tool icon .
Finish commissioning
When commissioning is completed successfully, the settings are stored in the converter in a
non-volatile manner. The option to perform an optimization of the motor data is displayed.
The option can be deselected.
Commissioning (web server)
10.5Functions and menus
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 231
To Next Page
Loading...
