3. Insert Option Module OM-IIoT into the option slot of the converter.
Figure5-22 Mounting Option Module OM-IIoT in the option slot of the converter
4. Push Option Module OM-IIoT up until it snaps in ush.
5. Tighten the xing screw with a T20 torx screwdriver, applying a torque of 2 Nm.
6. Replace the housing cover and tighten the screws with a T20 torx screwdriver, applying a
torque of 2Nm.
7. Press the cover caps onto the xing screws.
Result
Option Module OM-IIoT is connected to the converter.
Installation
5.7Option modules
SINAMICS G220 converter
120 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB
To Next Page
Loading...
