Siemens SINAMICS G220 - Page 768

– Enter the drive password of the source converter.
The drive data are loaded into the converter from the backup 󹪝le.
As a consequence, the status of the settings at the instant of the backup are restored.
Function "Drive data encryption" is activated. The drive password of the source converter
is transferred to the target converter.
• Scenario 3: A di󹪜erent drive password is con󹪝gured in the target converter and the source
converter.


1 2
3
$SFBUFCBDLVQ꫼MF3FTUPSFESJWFEBUB
$POWFSUFS"$POWFSUFS#$POWFSUFS#
୫3FQMBDFDPOWFSUFS"
ࡒ#
%SJWFQBTTXPSEGPSDPOWFSUFS"
%SJWFQBTTXPSEGPSDPOWFSUFS#







– Click on "Restore".
A dialog to enter the password opens.
– Enter the drive password of the target converter.
A dialog to enter the password opens.
– Enter the drive password of the source converter.
The drive data are loaded into the converter from the backup 󹪝le.
As a consequence, the status of the settings at the instant of the backup are restored.
Function "Drive data encryption" is activated. The drive password of the source converter
is transferred to the target converter. When doing this, the drive password of the target
converter is overwritten.
Corrective maintenance
16.1Replacing a converter
SINAMICS G220 converter
766 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB