Procedure
Proceed as follows to dene the communication between the OM-IIoT and the edge device:
1. Set the following:
– "Name of Station" of the OM-IIoT
Only lower case letters and numbers are permissible: a, b, c, … z, 0, 1, … 9.
– IP address of the OM-IIoT
– IP address of the edge device
– UDP port of the edge device
Permissible values: 33333 … 33340
2. Interconnect the converter signals that you wish to transfer to the edge device with the OM-
IIoT.
Commissioning (Startdrive)
11.3Device conguration and basic parameterization
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 287
To Next Page
Loading...
