Siemens SINAMICS G220 - Page 160

Procedure
Proceed as follows to remove the housing cover:






Figure7-4 Removing the IP55 housing cover
1. Using a torx screwdriver, release the 󹪝xing screws of the housing cover.
The screws are connected to the housing cover and are captive.
2. Swivel the housing cover towards the front and then lift the housing cover upward.
Proceed as follows to install the housing cover:








Figure7-5 Attaching the IP55 housing cover
1. Place the housing cover with the recess at the converter housing and swivel the housing
cover downward.
2. Using a torx screwdriver, tighten the 󹪝xing screws of the housing cover. Tightening torque:
2Nm(26.6lbfin).
Connecting
7.1Line system, motor and braking resistor
SINAMICS G220 converter
158 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB