Siemens SINAMICS G220 - Page 204

Requirement
Terminal strip X124 of the converter must be supplied with 24V to use the 24 V supply of the
DRIVE-CLiQ interface.
Description
The RJ45 sockets of the two DRIVE-CLiQ interfaces are located on the lower side of option
module OM-DQ.
Table 7-33 DRIVE-CLiQ interface
X501
X502
PIN Designation Technical data
1 TXP Transmit data +
2 TXN Transmit data -
3 RXP Receive data +
4 Reserved, do not use -
5 Reserved, do not use -
6 RXN Receive data -
7 Reserved, do not use -
8 Reserved, do not use -
A +(24V) 24V power supply
B M (0V) Electronics ground
The blanking covers for the DRIVE-CLiQ interfaces are included in the scope of delivery.
Connecting
7.2Interfaces for the controller
SINAMICS G220 converter
202 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB