Siemens SINAMICS G220 - Page 230

Display for checking of the modi󹪝ed values
At least one of the values needs to be modi󹪝ed.
Mandatory to complete quick setup
Figure10-5 Quick setup using the web server
The most important properties of the converter are con󹪝gured in quick setup.
The converter creates a restore point when quick setup is started. The converter saves the
changes after every commissioning step. The converter is reset to the restore point if quick
setup is canceled.
The web server has a read-only mode for quick veri󹪝cation of the con󹪝guration data set.
Quick Setup Wizard
The Quick Setup Wizard performs the following steps:
• "Drive information"
• The function view contains information about the converter and 󹪝eld bus interface used and
the motor type. Any option modules added to the converter are also shown here.
The following data can be changed:
– Drive name
A speci󹪝c drive name can be assigned.
• "Motor"
If the motor is connected via the DRIVE-CLiQ connection, for example, this is detected during
startup. The motor data is transferred directly.
If the motor is not detected, the preset motor data is based on the drive information. The
following options are provided for de󹪝ning the motor con󹪝guration:
– Check the preset motor data against the rating plate of the motor connected and correct
if necessary
Information about the data set can be retrieved using the symbol.
– Specify the motor type used, for example by selecting or actually entering the motor ID
Con󹪝rming that the motor data matches the motor connected continues the quick setup
process.
The motor data con󹪝guration encompasses the following parameters:
– Standard
– Motor type
– Motor connection type
– Direction of motor rotation
– Properties of the motor
– Optional settings
Commissioning (web server)
10.5Functions and menus
SINAMICS G220 converter
228 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB