Siemens SINAMICS G220 - Page 284

Example
In the following application, you create a user-de󹪝ned list with the objective of accepting
parameter values for an additional drive.
1. You create a user-de󹪝ned list with parameter values for a con󹪝gured drive.
2. You open the list in another drive with the same hardware con󹪝guration.
3. You compare the parameter values of the drive with the saved values.
4. You apply the required parameter values for the drive.
More information
Detailed information about handling parameter lists and user-de󹪝ned lists is provided in the
TIAPortal information system.
Commissioning (Startdrive)
11.2Basics
SINAMICS G220 converter
282 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB