Menu level 1 Menu level 2 Menu level 3 Menu level 4 S: Standard
E: Extended
Drive control Setpoint addition E
Speed setpoint lter E
Speed controller Torque limiting S
Kp/Tn adaptation E
Torque setpoints Speed controller torque limiting E
Torque limiting Torque limiting upper E
Torque limiting lower E
Current setpoint lter E
Flux setpoint E
Current controller E
Power unit S, E
Motor – S
Motor data E
Drive functions Brake control S, E
DC brake S, E
Vdc min/max controller E
Automatic restart S, E
Flying restart S, E
Messages / monitoring
functions
Speed messages
Actual speed value alarms S, E
Speed messages E
Setpoint / actual value
alarms
E
Blocking messages E
Load torque monitoring E
Motor temperature S, E
Variable signaling function E
Stall message E
Friction characteristic Recording of the friction characteristic E
Bypass operation E
Encoder functions Zero mark tolerance E
Absolute position incremental encoder E
Technology functions Technology controller
Technology motorized potentiometer S, E
Technology xed setpoints S, E
Technology setpoints / actual values S, E
Technology PID controller S, E
Certain defaults, such as operating mode and motor, aect the display of extended functions.
Functions displayed in both the "Standard" and the "Extended" view may dier in terms of the
scope of parameterization options.
Commissioning (Startdrive)
11.8Extended parameterization
SINAMICS G220 converter
294 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB
To Next Page
Loading...
