Siemens SINAMICS G220 - Page 306

Functions of the control keys:
• 4 arrows
Navigation within a level
• OK
– Con󹪝rm selection
– Switch to editing mode
– Navigation to the next level down
• ESC
– Navigation to the next level up
– The navigation bar can be called from any level by pressing the ESC key for 2 seconds
– Switch focus from content area to navigation bar
– Switch focus from navigation bar to content area
• ON
Start the motor in MANUAL mode
• OFF
Stop the motor in MANUAL mode
• MANUAL/AUTO
– MANUAL: Speci󹪝es SINAMICS SDI Standard as the command source
– AUTO: Speci󹪝es an external source such as the 󹪝eld bus as the command source
The display is divided into the following areas:
• Status bar
Icons provide information about the status of the converter and about alarms and faults and
their causes.
The status bar is subdivided into 2 areas: The left-hand area provides information about the
converter status. The right-hand area contains details relating to converter function.
• Content area
The content area shows the current menu with additional menu items or information.
• Navigation bar
The navigation bar appears on the start page and at the 󹪝rst level of each menu item.
Menu selection:
– Select icon using "right" and "left" arrow keys
– Con󹪝rm with the "OK" key
• Footer
The footer contains the icons for possible actions. The actions are con󹪝rmed using the "ESC"
key or the "OK" key.
Operation and monitoring with SINAMICS SDI Standard
13.3Structure
SINAMICS G220 converter
304 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB