Siemens SINAMICS G220 - Page 378

QWLPHV
&RPSRQHQWQXPEHU
)DXOWW\SHVHHWDEOH
6LJQDOLQJFRPSRQHQWV
1RFRPSRQHQWDVVLJQPHQW
1RWXVHG
0HVVDJHUHFHLYHG
0HVVDJHJRQHQRDGGLWLRQDOPHVVDJHDFWLYHRQWKHFKDQQHO
)DXOW!'LDJQRVWLFV
$ODUP&ODVVUELW
ැ0DLQWHQDQFHUHTXLUHG
$ODUP&ODVVUELW
ැ0DLQWHQDQFHUHTXLUHG
0HVVDJHJRQHQRDGGLWLRQDOPHVVDJHDFWLYHRQWKHFKDQQHO
KH[
KH[KH[
0DLQWHQDQFH%LW
6SHFLILHU%LW
&KDQQHOGLDJQRVLVGDWD







%ORFNKHDGHU
%ORFNW\SH
%ORFNOHQJWK
%ORFNYHUVLRQKLJK
%ORFNYHUVLRQORZ
$3,
6ORWQXPEHU
6XE6ORWQXPEHU
&KDQQHOQXPEHU
&KDQQHOSURSHUWLHV
8VHUVWUXFWXUHLGHQWLILHU
%\WH%\WH%\WH
%\WH%\WH%\WH
%\WH%\WH%\WH%\WH%\WH%\WH
$FFXPXODWLYH%LW
7\SH%LW

'LUHFWLRQ%LW
&KDQQHOHUURUW\SH&KDQQHOSURSHUWLHV
KH[KH[
&KDQQHOQXPEHU
888
9000 hex Hardware/software error 900A hex Position/speed actual value incorrect or not avail‐
able
9001 hex Network fault 900B hex Internal (DRIVE-CLiQ) communication error
9002 hex Supply voltage fault 900C hex Infeed faulted
9003 hex DC link overvoltage 900D hex Braking module faulted
9004 hex Power electronics faulted 900E hex Line 󹪝lter faulted
9005 hex Overtemperature of the electronic components 900F hex External measured value / signal state outside the
permissible range
9006 hex Ground fault / inter-phase short circuit 9010 hex Application / technological function faulted
9007 hex Motor overload 9011 hex Error in the parameterization / con󹪝guration /
commissioning procedure
9008 hex Communication error to the higher-level control
system
9012 hex General drive fault
9009 hex Safety monitoring channel has identi󹪝ed an error 9013 hex Auxiliary unit faulted
Figure14-27 Structure of the channel diagnostics
To read out the diagnostics data, the control requests the diagnostics data from the converter
via "Read data set", e.g. using a read record with index 800C hex.
The following rules apply:
• 1 message block (=ChannelDiagnosisData)
if (one or several) faults of the same message class are detected at the converter
• n message blocks
if at the converter, n faults of di󹪜erent message classes are detected
Functions
14.4PROFINET communication
SINAMICS G220 converter
376 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB