Siemens SINAMICS G220 - Page 441

Parameters
The following list contains the parameters of the "Motorized potentiometer as setpoint source
for the main setpoint" function.
Number Name Unit
p1030[0...n].0...4 Motorized potentiometer con󹪝guration 
c1035[0...n] Motorized potentiometer setpoint raise 
c1036[0...n] Motorized potentiometer lower setpoint 
p1037[0...n] Motorized potentiometer maximum speed [rpm]
p1038[0...n] Motorized potentiometer minimum speed [rpm]
p1040[0...n] Motorized potentiometer starting value [rpm]
c1043[0...n] Motorized potentiometer accept setting value 
c1044[0...n] Motorized potentiometer setting value 
p1047[0...n] Motorized potentiometer ramp-up time [s]
p1048[0...n] Motorized potentiometer ramp-down time [s]
r1050 Motorized potentiometer setpoint after ramp-function
generator
[rpm]
c1070[0...n] Main setpoint 
c1071[0...n] Main setpoint scaling 
r1073 Main setpoint e󹪜ective [rpm]
c1075[0...n] Supplementary setp 
c1076[0...n] Supplementary setpoint scaling 
Functions
14.9Setpoint channel
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 439