Siemens SINAMICS G220 - Page 466

- 3030 -
1
Setpoint channel Main/supplementary setpoint, setpoint scaling, jogging
© Siemens AG
2 3 4 5 6 7 8
V6.02.00
<2>
t t t
n
p1082 p1058 p1059
-p1082
p1120
p1121
p1120
p1121
1 1 0 0
r0898.8 r0898.9
+
+
0 1
0 0
0 1 1 0 1 1
t
x,y x
y
c1071 [C]
(100.00)
Main setpoint
scaling [%]
c1070 [C]
(1061)
Main setpoint
c1075 [C]
(0.00)
Supplementary setp [rpm]
c1076 [C]
(100.00)
Supplementary setpoint
scaling [%]
r0807.0 1 = Master control active
r1073 Main setpoint effective [rpm] r1077 Supplementary setpoint effective [rpm]
r1078
Total setpoint
effective [rpm]
r0898 r0898.8
1 = Jog 1
Old value is kept
[2501.7]
c1055
[2501.7]
c1056
[3040.1]
Setpoint from external operating tool or operator panel.
Interpolator clock cycle
for speed setpoints
0.00 ... 127.00 [ms]
p1079 (0.00)
Jog 2 speed setpoint
-210000.000 ... 210000.000 [rpm]
p1059 [D] (-150.000)
Jog 1 speed setpoint
-210000.000 ... 210000.000 [rpm]
p1058 [D] (150.000)
r0898 r0898.9
1 = Jog 2
Jogging can only be activated in the operating state “Ready for operation (S2)“.
The interconnection to the source for the main and supplementary setpoints is automatically established with the appropriate settings in the HMI device, e.g. by the telegram selection. For the
factory setting, r1024 is interconnected to the main setpoint c1070 via the universal setpoint (c1060/r1061)
<1>
<1>
<2> <2>
Speed setpoint_1
Figure14-78 3030 - Main/supplementary setpoint, setpoint scaling, jogging
Functions
14.9Setpoint channel
SINAMICS G220 converter
464 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB