Siemens SINAMICS G220 - Page 500

- 6301 -
1
Vector control U/f control, voltage boost
© Siemens AG
2 3 4 5 6 7 8
V6.02.00
1 0
0
r1199 r1199.0 1 = Ramp-up active
r0067
Output current maximum [Arms] [6300.1]
Starting current (voltage boost)
when accelerating [%]
p1311 [D] (0.0)
Starting current (voltage boost)
when starting [%]
p1312 [D] (0.0)
r0056 r0056.5
1 = Voltage boost when starting
Starting current (voltage boost)
permanent [%]
p1310 [D] (50.0)
Rated motor current [Arms]
p0305 [M] (0.00)
r0056 r0056.6
1 = Acceleration voltage
1 0
0
>0 >0
+
+
+
0
Actual stator resistance [ohm] r0395 [M]
<1> p1312 is only effective for the first acceleration phase after pulse enable.
<1>
3
[6302.1]
Voltage boost
[2526.4] [2526.4]
Figure14-108 6301 - Voltage boost
Functions
14.10Closed-loop drive control
SINAMICS G220 converter
498 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB