Siemens SINAMICS G220 - Page 574





$MPDLXJTFSPUBUJPO
$PVOUFSDMPDLXJTFSPUBUJPO
0/0''$MPDLXJTFSPUBUJPO
0/0''$PVOUFS
DMPDLXJTFSPUBUJPO
U
4QFFETFUQPJOU
450145014501

Figure14-169 Two-wire control, clockwise/counter-clockwise rotation 2
Table 14-83 Function table
ON/OFF1 clockwise rota‐
tion
ON/OFF1 counter-clock‐
wise rotation
Function
0 0 The motor stops.
The converter brakes the motor to a standstill.
1 0 The motor starts.
The converter accelerates the motor in the
"clockwise" direction.
0 1 The motor starts.
The converter accelerates the motor in the
"counter-clockwise" direction.
1 1 The motor stops.
The converter brakes the motor to a standstill.
Parameters
The following list contains the parameters of the "Motor control with clockwise/
counterclockwise commands" function.
Number Name Unit
r0722.0...22 Digital inputs status 
c0840[0...n] ON / OFF (OFF1) 
c1113[0...n] Setpoint inversion 
c3330[0...n] 2/3 wire control command 1 
c3331[0...n] 2/3 wire control command 2 
r3333.0...3 2/3 wire control control word 
p3334 2/3 wire control selection 
Functions
14.11Drive functions
SINAMICS G220 converter
572 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB