Siemens SINAMICS G220 - Page 765

Procedure
1. Call menu "Backup and restore" in the web server.
2. Navigate to the "Restore drive data from backup 󹪝le" area.
3. Use the "Click to select 󹪝le, or drag and drop 󹪝le here" button to select the backup 󹪝le.
4. To restore the drive data, proceed as described below depending on the speci󹪝c application.
This step is included in the following diagrams as step 3.
• Scenario 1: No drive password is con󹪝gured in the source and target converters.
1 2 3
$SFBUFCBDLVQ꫼MF
3FTUPSFESJWFEBUB
$POWFSUFS"
$POWFSUFS#$POWFSUFS#
୫3FQMBDFDPOWFSUFS"
ࡒ#
– Click on "Restore".
The drive data are loaded into the converter from the backup 󹪝le.
As a consequence, the status of the settings at the instant of the backup are restored.
• Scenario 2: No drive password is con󹪝gured in the source converter. On the other hand, in
the target converter function "Drive data encryption" had been previously activated and a
drive password con󹪝gured.
1 2 3
$SFBUFCBDLVQ꫼MF
3FTUPSFESJWFEBUB
%SJWFQBTTXPSEGPSDPOWFSUFS#
$POWFSUFS"
$POWFSUFS#$POWFSUFS#
୫3FQMBDFDPOWFSUFS"
ࡒ#



– Click on "Restore".
The drive data are loaded into the converter from the backup 󹪝le.
As a consequence, the status of the settings at the instant of the backup are restored.
Function "Drive data encryption" is activated. The con󹪝gured drive password is still
e󹪜ective in the target converter after data has been restored.
Corrective maintenance
16.1Replacing a converter
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 763