7. Switch on the converter supply voltage.
If required, the rmware of the connected DRIVE-CLiQ components is updated. This may
require a restart (see active alarms in the web server).
RDY Explanation of LED displays
Firmware of the connected DRIVE-CLiQ components being updated:
• Do not switch o the power supply.
• Do not disconnect the motor from the converter.
Firmware of the DRIVE-CLiQ components has been updated:
• Remedy: Switch the component supply voltage o and then on again.
8. Check whether the new version is installed. The rmware version of the converter is
displayed on the home page of the web server next to the image of the converter.
Corrective maintenance
16.3Firmware update via memory card
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 769
To Next Page
Loading...
