3. Connect your PC to network connection X128 of the OM-IIoT via a network cable.
4. Switch on the converter power supply.
5. Wait until LED COM on the OM-IIoT lights up green.
6. Congure the IP address and the subnet mask of your PC.
PC and OM-IIoT must be in the same network segment.
7. In the le explorer of the PC, go to the folder in which you saved le "clear_pairing".
8. Enter "cmd" + <↵> in the address bar of the le explorer.
9. The PC opens the command prompt in a new window:
D:\IIOT\clear_public_key> _
10.Enter command "ping xxx.xxx.xxx.xxx" with the IP address of the OM-IIoT:
D:\IIOT\clear_public_key> ping 169.254.1.42
Corrective maintenance
16.5Deleting the Public Key of option module OM-IIoT
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 775
To Next Page
Loading...
