Proceed as follows to remove the fan unit:
1. Remove the shield connection plate by undoing the 2 screws using a torx screwdriver.
2. For converters, frame sizes FSA … FSC, withdraw the connector for the braking resistor.
3. Press a slotted screwdriver against one of the two rear catches and at the same time pull the
corresponding side of the fan unit out of the housing using the lug.
Corrective maintenance
16.11Replacing fans
SINAMICS G220 converter
784 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB
To Next Page
Loading...
