3. Remove the hole drilling template, the separately packaged accessories and the packaging
material:
①
②
③
Hole drilling template
Accessories
Packaging material
4. Grasp the bottom of the converter on both sides at the center and lift the converter out of the
packaging.
For IP20 converters larger than frame size FSD1 and IP55 converters from frame size FSC and
higher, we recommend that the packaging is completely cut away and lifting equipment is
attached to the converter attachment points.
Installation
5.3Unpacking the converter
SINAMICS G220 converter
96 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB
To Next Page
Loading...
