Phaser 6180MFP Multifunction Printer Service Manual 3-15
Error Messages and Codes
033-776 Fax Codec Error
(SCAN Encode Output Buffer Over)
page 3-210
033-777 Fax Codec Error
(FAX RX Decode Input Buffer Over)
page 3-206
033-782 Fax Codec Error
(NSS/DCS Function Disagreement)
page 3-206
033-784 Fax Codec Error page 3-206
033-786 Fax Codec Error page 3-210
033-787 Memory Full page 3-187
033-788 Memory Full (MFP Memory Full) page 3-187
033-789 Fax Job Cancelled (Cancel) page 3-212
033-790 Fax Job Cancelled (Cancel) page 3-212
033-791 Fax Job Cancelled (Cancel) page 3-212
033-795 Fax Send Error (Fax Send Count Limit)
033-799 Fax Codec Error
(Maximum Reception Lines Over)
page 3-206
034-508 Fax Communication Error
(Command Refuse Signal Send)
page 3-214
034-515 Fax Communication Error
(DIX DCS Illegal Command Receive)
page 3-215
034-799 Fax Number Error (No Dial Data) page 3-216
035-701 Target Fax No Answer (Send T1 Time Out) page 3-217
035-702 Fax Communication Error (Receive DCN) page 3-218
035-704 Fax Communication Error (Not Send Ability) page 3-218
035-705 Fax Communication Error
(DCS/NSS Resend Over)
page 3-218
035-706 Fax Communication Error (Fall Back Error) page 3-200
035-708 Fax Communication Error
(Post Message Resend Over)
page 3-218
035-709 Fax Communication Error
(G3 Send RTN/PIN Receive)
page 3-218
035-710 Fax Communication Error (Receive PIN) page 3-218
035-716 Fax Communication Error (T2 Time Out) page 3-218
035-717 Fax Communication Error
(G3 Receive RTN Send)
page 3-218
035-718 Target Fax No Answer (Receive T1 Time Out) page 3-217
035-720 Fax Communication Error (No Receive Ability) page 3-221
035-728 Fax Communication Error (G3 EOL Not Receive) page 3-218
Error Message and Chain Link Code Display (continued)
Chain Link
Code
Control Panel Message Go to Page
To Next Page
Loading...
Need help?
General
