3-196 Phaser 6180MFP Multifunction Printer Service Manual
Error Messages and Codes
Fax Communication Error
Fax communication has occurred. The following troubleshooting procedure
applies to these errors.
Applicable Chain Link
■ Chain Link 033-512: Fax Communication Error (Modem Parameter
Exchange Error)
■ Chain Link 033-513: Fax Communication Error (Stop Communication in
Memory Full)
■ Chain Link 033-751: Fax Communication Error (Over Run)
■ Chain Link 033-764: Fax Communication Error (Draw Data Create Not
Do)
■ Chain Link 035-730: Fax Communication Error (RS Request CS NOT
ON)
■ Chain Link 035-779: Fax Communication Error (FAX FWD Document
Change Error)
■ Chain Link 133-231: Fax Communication Error (T_FAXCOM Data
Receive I/F Error)
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Scanner Controller Board, PL9.1.1
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Turn the printer power Off and back
On.
2.Does the error still occur?
Go to step 2. Complete.
2 1.Check the Country setting: System >
Admin Menu > Fax Settings >
Country.
2.Is the Country setting correct?
Go to step 3. Change the
Country Setting
to the correct
country.
To Next Page
Loading...
