Phaser 6180MFP Multifunction Printer Service Manual 3-95
Error Messages and Codes
Configuration, Memory, and Firmware Errors
Incorrect PagePack Password
Flash error has occurred. The following troubleshooting procedure applies to
this error.
Applicable Chain Link
■ Chain Link 016-220: Too Many Incorrect Numeric Passwords (PagePack
Password Error)
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
o
e
Be sure to move the NVRAM chip from the old I/P Board to the new I/P
Board. Carefully check the correct orientation of the NVRAM ROM when
installing the NVRAM ROM.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Image Processor Board, PL9.1.20
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Check the password.
2.Did the user enter the correct
password for PagePack?
Go to step 2. Re-enter the
correct
password for
PagePack.
2 Does the error still occur when the
printer is turned On?
Replace the
Image
Processor Board
(page 8-90).
Complete.
To Next Page
Loading...
