Phaser 6180MFP Multifunction Printer Service Manual 8-47
Service Parts Disassembly
Tray 2 Feeder Unit (PL3.2.1)
1. Remove Tray 2.
2. Open the Front Cover.
3. Remove the Fuser (page 8-12).
4. Remove the Rear Cover (page 8-18).
5. Remove the Bottom Cover (page 8-19).
6. Remove the Right Pole Inner Cover (page 8-21).
7. Remove the Right Pole Cover (page 8-22).
8. Remove the Right Cover (page 8-23).
9. Remove the Drive Assembly (page 8-78).
10. Remove the Registration Clutch (page 8-45).
11. Remove the Feed Clutch (page 8-46).
12. Remove the Tray 1 (MPT) Roll (page 8-42).
o
e
It is not necessary to remove the Tray 1 (MPT) No Paper Sensor
(PL3.1.15) and the Cover Sensor (PL3.1.16).
13. Remove 2 screws (10 mm) securing the MPT Chute (PL3.1.14) to the
printer.
14. Remove the MPT Chute from the printer.
s6180mfp-271
To Next Page
Loading...
