Xerox Phaser 6180MFP - Fax Send Error

Phaser 6180MFP Multifunction Printer Service Manual 3-213
Error Messages and Codes
Fax Send Error
The Fax has failed. The following troubleshooting procedure applies to this
error.
Applicable Chain Link
■ Chain Link 033-795: Fax Send Error (Fax Send Count Limit)
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Scanner Controller Board, PL9.1.1
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Check the original documents.
2.Are the documents 100 sheets or
more?
Go to step 2. To go step 3.
2 1.Separate the original documents
into small sections to be faxed.
2.Does the error still occur when
faxing?
Go to step 3. Complete.
3 1.Check the Scanner Controller Board
for correct installation. Reseat the
Scanner Controller Board
(page 8-99).
2.Does the error still occur when
faxing?
Replace the
Scanner
Controller Board
(page 8-99).
Complete.