Xerox Phaser 6180MFP - Registration Clutch (PL3.1.19)

Phaser 6180MFP Multifunction Printer Service Manual 8-45
Service Parts Disassembly
Registration Clutch (PL3.1.19)
1. Open the Front Cover.
2. Remove the Fuser (page 8-12).
3. Remove the Rear Cover (page 8-18).
4. Remove the Bottom Cover (page 8-19).
5. Remove the Right Pole Inner Cover (page 8-21).
6. Remove the Right Pole Cover (page 8-22).
7. Remove the Right Cover (page 8-23).
8. Remove the Drive Assembly (page 8-78).
9. Disconnect connector P/J233.
10. Release the Gray Registration Clutch wiring harness from the clamp and
hook on the printer frame, and the clamp of the Feeder (PL3.2.1).
11. Remove the E-ring securing the Registration Clutch to the Feeder.
12. Remove the Registration Clutch from the Feeder.
R
ep
l
acemen
t
N
o
t
e
R
ep
l
acemen
t
N
o
t
e
Be sure to match the color of the Clutch Harness and the color of the
Clutch positioning rib. The Registration Clutch Harness is Gray.
s6180mfp-269
P/J233
Grey
Grey