3-144 Phaser 6180MFP Multifunction Printer Service Manual
Error Messages and Codes
Environmental (Humidity/Temperature) Sensor Error
The Environmental Sensor has detected temperature error. The following
troubleshooting procedure applies to this error.
Applicable Chain Link
■ Chain Link 092-661: Environmental Sensor Error (IOT Environment
Sensor Error)
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Humidity/Temperature Sensor
PL9.2.11
■ MCU Board, PL9.2.13
■ Humidity Harness, PL10.1.15
■ “Map 4 - LVPS and MCU Board” on
page 10-13
■ “Xerographic” on page 10-34
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Check the Humidity/Temperature
Sensor for correct installation.
2.Is the Humidity/Temperature Sensor
correctly installed?
Go to step 2. Reseat the
Humidity/
Temperature
Sensor.
Go to step 2.
2 Does the error still occur when the
printer is turned On?
Go to step 3. Complete.
3 1.Check the wiring harness
connectors P/J26 and P/J261
between the MCU Board and the
Humidity/Temperature Sensor.
2.Are the connectors securely
connected?
Go to step 4. Reconnect the
connectors.
To Next Page
Loading...
