Xerox Phaser 6180MFP - Fax Codec Error

3-210 Phaser 6180MFP Multifunction Printer Service Manual
Error Messages and Codes
Fax Codec Error
The Fax has failed. The following troubleshooting procedure applies to these
errors.
Applicable Chain Link
■ Chain Link 033-765: Fax Codec Error (File Pointer Error)
■ Chain Link 033-766: Fax Codec Error (Target File Opening)
■ Chain Link 033-767: Fax Codec Error (MMR MN86064 Decode Error)
■ Chain Link 033-768: Fax Codec Error (ATMove Counter Over)
■ Chain Link 033-770: Fax Codec Error (YD Error)
■ Chain Link 033-771: Fax Codec Error (Abort Marker Error)
■ Chain Link 033-774: Fax Codec Error (FAX TX Encode Output Buffer
Over)
■ Chain Link 033-776: Fax Codec Error (SCAN Encode Output Buffer
Over)
■ Chain Link 033-786: Fax Codec Error
■ Chain Link 133-237: Fax Codec Error (MHR Input Buffer Error)
■ Chain Link 133-238: Fax Codec Error (MHR Output Buffer Error)
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Scanner Controller Board, PL9.1.1
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Turn the printer power Off and back
On.
2.Does the error still occur?
Go to step 2. Complete.
2 1.Check the Country setting: System >
Admin Menu > Fax Settings >
Country.
2.Is the Country setting correct?
Go to step 3. Change the
Country Setting
to the correct
country.