Phaser 6180MFP Multifunction Printer Service Manual 3-183
Error Messages and Codes
Control Panel Error
The parameter setting on the Control Panel has failed. The following
troubleshooting procedure applies to these errors.
Applicable Chain Link
■ Chain Link 062-323: Panel Setting Parameter NG
■ Chain Link 123-314: Control Panel Error
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Control Panel, PL1.2.2
■ Scanner Controller Board, PL9.1.1
■ “Map 1 - Electrical and Drive” on
page 10-10
■ “Automatic Document Feeder Wiring
Diagram” on page 10-53
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Wait for 5 seconds and turn the
printer Off and back On.
2.Does the error still occur when the
printer is turned On?
Go to step 2. Complete.
2 1.Check the Scanner Controller Board
for correct installation. Reseat the
Scanner Controller Board
(page 8-99).
2.Does the error still occur when the
printer is turned On?
Go to step 3. Complete.
3 1.Check the Control Panel for correct
installation. Reseat the Control
Panel (page 8-30).
2.Does the error still occur when the
printer is turned On?
Go to step 4. Complete.
4 1.Replace the Scanner Controller
Board (page 8-99).
2.Does the error still occur when the
printer is turned On?
Replace the
Control Panel
(page 8-30).
Complete.
To Next Page
Loading...
