3-110 Phaser 6180MFP Multifunction Printer Service Manual
Error Messages and Codes
Range Check Error
An error occurred while writing to Flash memory. The following
troubleshooting procedure applies to this error.
Applicable Chain Link
■ Chain Link 016-743: Range Check Error (Download Range Error)
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Image Processor Board, PL9.1.20
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Check the printer firmware.
2.Does the firmware have the correct
version?
Go to step 2. Update the
firmware (refer
to “Firmware
Update” on
page A-3).
2 1.Check the Image Processor Board
for correct installation. Reseat the
Image Processor Board
(page 8-90).
2.Does the error still occur?
Replace the
Image
Processor Board
(page 8-90).
Complete.
To Next Page
Loading...
Need help?
General
