3-98 Phaser 6180MFP Multifunction Printer Service Manual
Error Messages and Codes
Engine Model Mismatch
Printer Engine model does not match. The following troubleshooting
procedure applies to this error.
Applicable Chain Link
■ Chain Link 016-611: Print Engine Model Mismatch (IOT Model
Mismatch)
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ MCU Board, PL9.2.13
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Turn the printer power Off and back
On.
2.Does the error still occur?
Replace the
MCU Board
(page 8-88).
Complete.
To Next Page
Loading...
