Phaser 6180MFP Multifunction Printer Service Manual 3-93
Error Messages and Codes
Duplexer Error
The Duplexer Unit has failed. The following troubleshooting procedure applies
to this error.
Applicable Chain Link
■ Chain Link 077-215: Duplexer Error
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Front Cover Harness, PL1.2.13
■ MCU Board, PL9.2.13
■ Right Side Harness, PL10.1.12
■ Duplex Unit, PL12.1.1
■ Duplex Unit Harness, PL12.1.18
■ “Map 1 - Electrical and Drive” on
page 10-10
■ “Map 2 - Laser Unit and Feeder” on
page 10-11
■ “Map 4 - LVPS and MCU Board” on
page 10-13
■ “Map 5 - Duplex Unit” on page 10-14
■ “Duplex Wiring Diagram” on page 10-48
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Check the Duplex Unit for correct
installation.
2.Is the Duplex correctly installed?
Go to step 3. Reseat the
Duplex Unit
(page 8-115).
Go to step 2.
2 Does the error still occur when the
printer turned On?
Go to step 3. Complete.
3 1.Check the wiring harness
connectors P/J27, P/J272, P/J2720,
and P/J428 between the Duplex
Board and the MCU Board.
2.Are the connectors securely
connected?
Go to step 5. Reconnect the
connectors.
Go to step 4.
4 Does the error still occur when the
printer is turned On?
Go to step 5. Complete.
To Next Page
Loading...
