Phaser 6180MFP Multifunction Printer Service Manual 3-167
Error Messages and Codes
Scanner and Copier Errors
Scanner ADF Cover Open
ADF Cover Open error has occurred. The following troubleshooting procedure
applies to this error.
Applicable Chain Link
■ Chain Link 005-301: Scanner ADF Cover Open (ADF Cover Open)
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Scanner Controller Board, PL9.1.1
■ ADF Scanner Assembly, PL11.1.1
■ “Map 3 - Image Processor Board and
Dispenser Motors” on page 10-12
■ “Automatic Document Feeder Wiring
Diagram” on page 10-53
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Is the ADF Cover closed? Go to step 2. Close the ADF
Cover.
2 1.Check the wiring harness connector
P/J60 on the Scanner Controller
Board. Reseat the connector.
2.Does the error still occur when the
printer is turned On?
Go to step 3. Complete.
3 1.Replace the ADF Scanner Assembly
(page 8-103).
2.Does the error still occur when the
printer is turned On?
Replace the
Scanner
Controller Board
(page 8-99).
Complete.
To Next Page
Loading...
