Xerox Phaser 6180MFP - Flash Error

3-96 Phaser 6180MFP Multifunction Printer Service Manual
Error Messages and Codes
Flash Error
Flash error has occurred. The following troubleshooting procedure applies to
these errors.
Applicable Chain Link
■ Chain Link 016-500: Erase Flash Error (Download Delete Error)
■ Chain Link 016-501: Write Flash Error (Download Write Error)
■ Chain Link 016-502: Write Flash Error (Download Verify Error)
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Image Processor Board, PL9.1.20
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Check the Image Processor Board
for correct installation. Reseat the
Image Processor Board
(page 8-90).
2.Does the error still occur when the
printer is turned On?
Replace the
Image
Processor Board
(page 8-90).
Complete.